This mount allows you to easily attach up to twoSurvey3,Survey2,Survey1 or GoPro Hero 4/3+/3 cameras to the Phantom 4 (PRO/ADV), Phantom 4droneswhile still keeping the original drone camera installed. Using the two side black thumb screws you can adjust the camera’s tilt angle from 0 to10 degrees to account for the forward flying tilt. Each notch is equal to 2.5 degrees of tilt.

Supported Models: Phantom 4 Pro V2.0,Phantom 4Pro,Phantom 4 Pro Obsidian,Phantom 4 RTK,Phantom 4 Multispectral,Phantom 4Advanced,Phantom 4.

Included:

(1) Durable &lightweight plastic mounting plates

(4) Dampening balls

(1) SingleSurvey camera mounting plate

(4)M2 screws (replaces existing DJI screws)

Camera Mount Weight (not including camera clips and cameras): 32.82g

Peau Productions (MAPIR) is in no way liable for any damage caused to or by your drone. We havethoroughlytested this mount and when installed properly will not interfere with the normal operation of the drone.

Install Instructions:

Step 1: The mount will already come assembled. Simply unscrew the original DJI screws in the 4 locations marked below with a (not included) 1.5mm hex tool:

Step 2: Place the mount as shown and tighten the 4 screws included with the mount:

Step 3: If using the Survey3 cameras peel off the adhesive backing on the bottom of the GPS receiver, and press it such that the GPS receiver adheres to the center of the mount.You can use a (not included) plastic tie as shown below to provide a more secure attachment.

Step 4: Happy flying!